# See /boot/overlays/README for all available options

dtoverlay=vc4-kms-v3d
initramfs initramfs-linux.img followkernel

# Automatically load overlays for detected DSI displays
display_auto_detect=1

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# Uncomment some or all of these to enable the optional hardware interfaces
#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

# Uncomment this to enable infrared communication.
#dtoverlay=gpio-ir,gpio_pin=17
#dtoverlay=gpio-ir-tx,gpio_pin=18

# Automatically load overlays for detected cameras
camera_auto_detect=1

# Uncomment to enable bluetooth
#dtparam=krnbt=on

[cm4]
# Enable host mode on the 2711 built-in XHCI USB controller.
# This line should be removed if the legacy DWC2 controller is required
# (e.g. for USB device mode) or if USB support is not required.
otg_mode=1

[pi4]
# Run as fast as firmware / board allows
arm_boost=1