github-mirrors/HeatPumpController
1
0
Fork 0
mirror of https://github.com/openhp/HeatPumpController.git synced 2024-11-08 12:25:43 +00:00
Code Issues Projects Releases Packages Wiki Activity Actions

Update README.md

Browse source
This commit is contained in:
openhp 2021-03-24 15:19:41 +00:00 committed by GitHub
parent 17b6b55ec6
commit 03869fe98a
No known key found for this signature in database
GPG key ID: 4AEE18F83AFDEB23
1 changed files with 1 additions and 1 deletions
Show stats Download patch file Download diff file Expand all files Collapse all files

2
README.md
View file

@ -273,7 +273,7 @@ Buy DS18B20s chips. Cheap or not cheap doesn't matter - I've never seen "bad" DS
<img src="./m_ds18b20_epoxy.jpg" width="500"><br><br>
For sensors at compressor and discharge (+100°C and higher) use heat resistant sleeves at every wire.<br>
<img src="./m_ds18b20_wires_protection.jpg" width="500"><br><br>
To get precise temperature readings sensors must be insulated from ambient air temperature influence with additional thermal insulation. Temperature readings from most of sensors are interesting, but +/- few degree does not matter. So most of sensors can be covered with insulation as you wish. But 2 sensors "Before evaporator" and "After evaporator" are critical to EEV and needs extra attention. Temperature of this sensors must be as close to the temperature of copper tube as it possible. So install Tae and Tbe sensors as pictured below. You can use thermal paste, but there is no significant difference with much more available silicone.<br>
To get precise temperature readings sensors must be insulated from ambient air temperature influence with additional thermal insulation. Temperature readings from most of sensors are interesting, but +/- few degree does not matter. So most of sensors can be covered with insulation as you wish. But 2 sensors "Before evaporator" and "After evaporator" are critical to EEV and needs extra attention. Temperature of this sensors must be as close to the temperature of copper tube as it possible. So install Tae and Tbe sensors as pictured below. You can use thermal paste, but there is no significant difference with much more available silicone. Tape isn't shown below, for clarity, but must be used on every insulation layer.<br>
<img src="./m_ds18b20_evaporator_mount.jpg" height="700"><br><br>
About water(glycol)<->refrigerant heat exchangers. You can use plate heat exchangers. Pros: best efficiency. Cons: costs money.<br>
<img src="./m_plate_heat_exchangers.jpg" width="500"><br><br>