github-mirrors/HeatPumpController
1
0
Fork 0
mirror of https://github.com/openhp/HeatPumpController.git synced 2024-11-18 12:33:59 +00:00
Code Issues Projects Releases Packages Wiki Activity Actions

Update README.md

Browse source
This commit is contained in:
openhp 2021-08-30 13:11:18 +00:00 committed by GitHub
parent ca8ae2f82e
commit 38546d3a45
No known key found for this signature in database
GPG key ID: 4AEE18F83AFDEB23
1 changed files with 8 additions and 8 deletions
Show stats Download patch file Download diff file Expand all files Collapse all files

16
README.md
View file

@ -98,17 +98,17 @@ Phases (1st wire in electrical cables):
<img src="./m_c_wiring_12v.jpg" width="600"><br>
Crimp and plug low-voltage connectors:
- crimp SCT013 sensor wires (the only one low-voltage device in this circuit with interchangeable wires), connect and install it on the inlet phase wire,
<img src="./m_c_wiring_current_sensor.jpg" width="600">
- crimp SCT013 sensor wires (the only one low-voltage device in this circuit with interchangeable wires), connect and install it on the inlet phase wire,<br>
<img src="./m_c_wiring_current_sensor.jpg" width="600"><br>
- crimp RS485 to the Remote Display, using a wire of desired length (note that A is connected to A, B to B and GND to GND),
- crimp 12V and GND secondary terminals to the remote display,
<img src="./m_c_wiring_display.jpg" width="600">
- connect EEV to EEV terminal,
<img src="./m_c_wiring_EEV.jpg" width="600">
- crimp 12V and GND secondary terminals to the remote display,<br>
<img src="./m_c_wiring_display.jpg" width="600"><br>
- connect EEV to EEV terminal,<br>
<img src="./m_c_wiring_EEV.jpg" width="600"><br>
- install all T sensors on pipes, insulate tubes,
- crimp T sensors arrays, you can crimp all four GND wires at every array to one GND connector pin or make 1-to-4 connection somewhere closer to sensors location (same for +5V wires),
- insert T sensors arrays to appropriate terminals (if you do not need to control over all temperatures, disable and do not install unnecessary sensors),
<img src="./m_c_wiring_t_sensors.jpg" width="600">
- insert T sensors arrays to appropriate terminals (if you do not need to control over all temperatures, disable and do not install unnecessary sensors),<br>
<img src="./m_c_wiring_t_sensors.jpg" width="600"><br>
- crimp and plug pressure sensors outputs: crimp 1st wires together to **12V** (right output of the terminal), 2nd cold side wire to the **Pco** (left), 2nd hot side wire to the **Phi** (middle); use the dummy if no pressure sensors used in your system.
<img src="./m_c_wiring_pressure.jpg" width="600"><br>
<img src="./m_c_wiring_pressure_dummy.jpg" width="600"><br>