mirror of
https://github.com/dexterbg/Twizy-ChargeThrottle.git
synced 2024-11-08 12:35:43 +00:00
52 lines
1.5 KiB
C
52 lines
1.5 KiB
C
/**
|
|
* ==========================================================================
|
|
* Twizy charge current throttle
|
|
* ==========================================================================
|
|
*/
|
|
#ifndef _TwizyChargeThrottle_config_h
|
|
#define _TwizyChargeThrottle_config_h
|
|
|
|
// Charge current throttle levels:
|
|
// 7 = 35 A = 2,3 kW (full power, no throttling)
|
|
// 6 = 30 A = 2,1 kW
|
|
// 5 = 25 A = 1,7 kW
|
|
// 4 = 20 A = 1,4 kW
|
|
// 3 = 15 A = 1,0 kW
|
|
// 2 = 10 A = 0,7 kW
|
|
// 1 = 5 A = 0,4 kW
|
|
// 0 = no throttling
|
|
|
|
// If not using a power level input, define a fixed throttling level like this:
|
|
// #define FIXED_LEVEL 5
|
|
// If this is defined, the power level inputs will not be used.
|
|
|
|
// Power level input:
|
|
// Use an 8 position binary coded rotary switch or a 3 pin DIP switch (or similar),
|
|
// define the input ports used here (analog ports may be used as well):
|
|
#define IN_LEVEL_B1 3
|
|
#define IN_LEVEL_B2 4
|
|
#define IN_LEVEL_B4 5
|
|
|
|
// Status outputs (e.g. LEDs):
|
|
#define OUT_CHARGING_PIN 8
|
|
#define OUT_THROTTLING_PIN 9
|
|
|
|
// Serial debug output level:
|
|
// 1 = show charge start/stop
|
|
// 2 = show current level changes
|
|
#define TWIZY_DEBUG 0
|
|
|
|
// Serial interface baud rate:
|
|
#define SERIAL_SPEED 115200
|
|
|
|
// Set your CAN MCP clock frequency here:
|
|
#define TWIZY_CAN_MCP_FREQ MCP_16MHZ
|
|
|
|
// Set your CAN CS pin number here:
|
|
#define TWIZY_CAN_CS_PIN 10
|
|
|
|
// Set your CAN IRQ pin here (0 = no IRQ):
|
|
#define TWIZY_CAN_IRQ_PIN 2
|
|
|
|
#endif // _TwizyChargeThrottle_config_h
|
|
|