mirror of
https://github.com/dexterbg/Twizy-Virtual-BMS.git
synced 2024-09-19 11:48:31 +00:00
84c84590ab
- Added support for Timer2 & Timer3 (see config header) - Added `setCurrentQA()` API call (native=fast 1/4 A resolution)
45 lines
1.5 KiB
C
45 lines
1.5 KiB
C
/**
|
|
* ==========================================================================
|
|
* Twizy Virtual BMS: Configuration
|
|
* ==========================================================================
|
|
*/
|
|
|
|
#ifndef _TwizyVirtualBMS_config_h
|
|
#define _TwizyVirtualBMS_config_h
|
|
|
|
// Serial debug output:
|
|
// Level 0 = none, only output init & error messages
|
|
// Level 1 = log state transitions & CAN statistics
|
|
// Level 2 = log CAN frame dumps (10 second interval)
|
|
#define TWIZY_DEBUG_LEVEL 1
|
|
|
|
// Set to 0 to disable CAN transmissions for testing:
|
|
#define TWIZY_CAN_SEND 1
|
|
|
|
// CAN send timing is normally 10 ms (10.000 us).
|
|
// You may need to lower this if your Arduino is too slow.
|
|
#define TWIZY_CAN_CLOCK_US 10000
|
|
|
|
// VirtualBMS can use Timer1 (16 bit), Timer2 (8 bit) or Timer3 (16bit)
|
|
// Select Timer2/3 if you need Timer1 for e.g. AltSoftSerial
|
|
#define TWIZY_USE_TIMER 1
|
|
|
|
// Timer2: precise resolutions depend on CPU type & clock frequency
|
|
// i.e. Arduino Nano 16 MHz: 1000 = 1 ms / 2000 = 0.5 ms / 5000 = 0.2 ms / 10000 = 0.1 ms
|
|
// Use lowest resolution possible to minimize side effects on AltSoftSerial
|
|
#define TWIZY_TIMER2_RESOLUTION 1000
|
|
|
|
// Set your MCP clock frequency here:
|
|
#define TWIZY_CAN_MCP_FREQ MCP_16MHZ
|
|
|
|
// Set your SPI CS pin number here:
|
|
#define TWIZY_CAN_CS_PIN 10
|
|
|
|
// Uncomment if you've connected the CAN module's IRQ pin:
|
|
//#define TWIZY_CAN_IRQ_PIN 2
|
|
|
|
// Set your 3MW (ECU_OK) control pin here:
|
|
#define TWIZY_3MW_CONTROL_PIN 3
|
|
|
|
#endif // _TwizyVirtualBMS_config_h
|