mirror of
https://github.com/archlinuxarm/wiki.git
synced 2024-11-08 22:45:42 +00:00
35 lines
1.1 KiB
Markdown
35 lines
1.1 KiB
Markdown
## Additional Packages
|
|
|
|
* X.org video driver package: xf86-video-odroid-c1
|
|
Note: Add your user to the "video" group to be able to access /dev/mali and /dev/ump.
|
|
* Mali EGL and GLES drivers (installed with xf86-video-odroid-c1): odroid-c1-libgl
|
|
* wiringPi modified for the ODROID-C1: wiring-odroid
|
|
* Kodi: kodi-c1
|
|
|
|
## IR
|
|
|
|
To make use of the IR receiver, load module meson-ir
|
|
|
|
## PWM
|
|
|
|
For one PWM (pin 33) and one SPI:
|
|
|
|
```
|
|
sudo modprobe pwm-peson npwm=1
|
|
sudo modprobe pwm-ctrl
|
|
```
|
|
|
|
For two PWM (pins 33 and 19) and no SPI
|
|
|
|
```
|
|
sudo modprobe pwm-peson npwm=2
|
|
sudo modprobe pwm-ctrl
|
|
```
|
|
|
|
You can control the PWM via simple sysfs entries. In /sys/devices/platform/pwm-ctrl you'll find the following files:
|
|
|
|
* duty0: Duty cycle in percent: `echo 50 > duty0 # 50% duty cycle`
|
|
* enable0: Enable/Disable this PWM: `echo 1 > enable0 # enable PWM0`
|
|
* freq0: PWM Frequency in Hertz: `echo 100000 > freq0 # set frequency to 100kHz`
|
|
* On PWM0 you can test higher frequencies; however, 1Mhz is the maximum supported frequency.
|
|
* Note: If you are using the two PWM setup, you will have: enable0, freq0, duty0 AND enable1, freq1, duty1.
|